Is R-20 continuous a rule for my existing Ottawa basement?
Is R-20 continuous a rule for my existing Ottawa basement?
R-20 continuous insulation is the value SB-12 sets for basement walls in new houses and additions. It is not a rule that applies to your existing basement simply because you are adding insulation.
For an existing house, Ontario's Building Code takes a different approach under Part 11. Section 11.3.1.1.(1) says that where an existing building system is materially altered or repaired, its performance afterward must be at least equal to its performance before the work. The Code does not set a target R-value for voluntarily topping up or insulating an existing basement wall; we found no Code number for that situation.
That said, the Home Renovation Savings program, run by Enbridge Gas and Save on Energy, does use R-value thresholds as rebate conditions for basement walls, and those are program rules, not Code requirements. If you are pursuing a rebate, the program's own rules govern what qualifies, and you should check those directly at homerenovationsavings.ca.
What the Code does say for any insulation work in an existing basement is worth knowing. Section 9.25.2.3 requires that insulation give a reasonably uniform value over the whole face and fill the full width and length of the space between framing. Where insulation runs along a basement wall enclosing a heated space, it must run the full height of that wall. Insulation and vapour barrier that could be mechanically damaged must be covered, for example with gypsum board, with one exception: in an unfinished basement, mineral fibre insulation covered with a membrane meeting the vapour barrier rules does not need a rigid covering. The vapour barrier itself must have a permeance no higher than 60 ng/(Pa·s·m²) and must be placed on the warm side of the assembly, as required by section 9.25.4.
On permits: insulation on its own is not named on the City of Ottawa's permit lists. If the basement work involves altering walls or structure, ask the City's Building Code Services before opening anything up.
When you have two written quotes in hand, set them side by side and check that each one names the insulation material, states the total wall area being covered in square feet, and gives the finished thickness and the resulting R-value, so you are comparing the same scope of work and not just the bottom-line price.
Want this done at your place?
Tell us which part of the house you want insulated and we'll send it to local Ottawa insulation contractors, who reply by email. We send it out to local contractors for you. Free, no pressure.
R-Value IQ -- Built from the Ontario Building Code, Ontario regulations and City of Ottawa sources and real construction experience. Answers are for informational purposes only and are not a professional assessment.
Ready to Get Quotes?
Find local insulation contractors in Ottawa. Free matching, no obligation.