Frequently Asked Questions
Answers to common questions from Ottawa homeowners about insulation rebates, the Building Code, permits, old insulation and hiring a contractor. Can't find what you're looking for? Ask R-Value IQ.
Rebates & Loans
Is there still a rebate for insulation in Ottawa?
Yes, for now. The Home Renovation Savings program (Enbridge Gas and Save on Energy) lists insulation rebates on two paths. The attic stream needs no energy assessment and pays 50% of the after-tax attic cost, up to a maximum of $800, $1,000 or $1,250 depending on how much insulation is there now, with work finished by November 30, 2026. The assessment path needs an energy assessment before any work and at least two upgrades, with the follow-up assessment booked by November 30, 2026 and done by December 31, 2026. A gas-heated home is capped at $5,000 in total. Funding may be fully allocated before those dates, and the federal Canada Greener Homes Grant and Loan are closed. We are not part of the program; check homerenovationsavings.ca (checked October 2026).
Which federal insulation programs have closed?
No. Natural Resources Canada says December 31, 2025 was the last day to submit documents for the Canada Greener Homes Grant, and the Canada Greener Homes Loan is closed: no further applications can be approved. Enbridge's older Home Efficiency Rebate ended intake on January 27, 2025. The Canada Greener Homes Affordability Program lists British Columbia, Manitoba, Nova Scotia, Prince Edward Island and Quebec as the provinces where residents can now apply; Ontario is not on that list (checked October 2026).
How does the City of Ottawa's Better Homes loan work?
The Better Homes Ottawa Loan Program lends money for energy upgrades, including insulation and air sealing, and you repay it through your property tax bill. The City lists a 20-year term, a 4.33% fixed rate, a $10,000 minimum, a maximum of $125,000 or 10% of the property's assessed value (whichever is less), a 4% administrative fee, and no penalty for repaying early. The program says an EnerGuide home assessment is a required step (checked October 2026).
Building Code
What R-values do new Ottawa houses get?
Ottawa is in Zone 1 of the Building Code's energy standard (SB-12) because its heating degree-days are under 5,000 (Ottawa City Hall: 4,440). For a new house heated by a gas furnace of at least 92% efficiency, package A1 lists R-60 in an attic, R-22 in above-grade walls, R-20 continuous on basement walls, R-31 for an exposed floor and R-10 under a heated or shallow slab. Other packages trade values, such as R-50 in the attic with other upgrades. These are values for new houses and additions, not a rule for an existing home.
Does topping up my attic have to reach R-60?
We found no Building Code rule that sets a number for topping up an existing attic. The Code sends renovations to Part 11: work that alters a building cannot leave its performance worse than before (O. Reg. 163/24, 11.3.1.1), and where framing being altered matches the existing framing, lesser amounts of insulation and vapour barrier are acceptable (Table 11.5.1.1.-C, C207). R-60 is the value for new houses and additions in Ottawa.
What does the Building Code say about spray foam?
Ontario's Building Code says: "Spray-applied polyurethane insulation shall be installed in accordance with CAN/ULC-S705.2" (O. Reg. 163/24, 9.25.2.5.(1)). That standard is for medium-density foam and sets installer requirements, so ask the installer for proof that they meet it. Foam in a wall or ceiling also has to be protected from the room by an interior finish such as drywall, or another thermal barrier the Code accepts, except where it faces a concealed attic, roof space, crawl space or cavity (9.10.17.10).
Permits
Does adding insulation need a City building permit?
Insulation on its own is not named on either of the City's lists: not among the projects that need no permit, and not among the permit projects. Ask the City before walls or the roof are opened. Work that can come with insulation is on the permit list: adding or removing walls, enlarging or relocating a window or door, and structural repairs or alterations. Finishing a basement has its own City permit page, and designated heritage buildings are not subject to the exemptions.
What does a City permit cost if my insulation job needs one?
On the City's 2026 fee schedule, a permit for alterations is $12.75 per $1,000 of the assessed value of the work, with a minimum fee of $117.00. The value is based on all materials, labour, overhead and professional fees.
Who should I ask before foam goes under my roof deck?
Your building inspector. For an unvented, spray-foamed roof, Natural Resources Canada advises: do not proceed without approval from your building inspector, and then only use a certified spray foam contractor who is familiar with the process. We found no City page that names this job, so ask the City first.
Old Insulation & Safety
What should I do if my attic has vermiculite?
Leave it alone and have it tested. Health Canada says it is prudent, in the absence of evidence to the contrary, to assume vermiculite insulation produced before 1990 may contain some asbestos; not to disturb it or attempt to remove it yourself; not to use the attic for storage; and to hire a professional to test for asbestos before renovating. Testing and removal are abatement work: see ottawaabatement.com.
What is UFFI, and when was it banned?
UFFI is urea formaldehyde foam insulation. Health Canada describes it as widely used in the 1970s, with the appearance and consistency of shaving cream, and says it has been prohibited from advertising, sale or importation into Canada since December 1980. It can release formaldehyde gas while curing and afterwards, and Health Canada notes those emissions decrease over time.
What does Health Canada say about spray foam kits?
Health Canada says two-part spray foam kits sold to consumers may pose a risk to your health and may cause breathing problems and skin sensitivities. If you hire a professional instead, it says to follow the contractor's instructions on when to leave the area and on how to keep it ventilated, and for how long.
Hiring a Contractor
Is there a licence for insulation installers in Ontario?
We found no Ontario or City of Ottawa licence for insulation installers. "Heat and frost insulator" is a trade in Ontario, but it is not a compulsory one and it is not an attic or wall insulation licence. For spray foam, ask for proof that the installer meets the CAN/ULC-S705.2 standard the Building Code names. You can also ask a contractor for a WSIB clearance certificate.
Someone came to my door selling insulation. What are my rights?
Ontario bans door-to-door contracts for some products, such as furnaces, air conditioners, water heaters and duct cleaning, unless you contacted the supplier first; insulation is not on that list. The general rules still apply: an agreement made at your home for more than $50 must be in writing, and you can cancel it for any reason within 10 days of receiving your written copy. Natural Resources Canada says it never goes door to door asking to enter homes.
How much should I hold back when paying an insulation contractor?
Ontario's Construction Act requires the payer to retain a holdback equal to 10 per cent of the price of the services or materials as they are actually supplied, until the liens that may be claimed against it have expired. Ask a lawyer about how that applies to your contract.
Costs & Quotes
Per square foot, what do attic, foam and removal jobs run?
Published 2025–2026 estimates from Ontario and Ottawa price pages put blown-in attic insulation at about $1.50 to $3.00 per square foot of attic (ask for the area on the quote), open-cell spray foam at about $1.00 to $2.75 per square foot, closed-cell at about $2.75 to $7, and removal of clean old insulation at about $0.75 to $2. Basement wall insulation runs about $2,000 to $8,000 for a typical job. These are published estimates, not rates; compare written quotes for the same area and R-value.
What should an insulation quote spell out?
The material and where it goes, the area in square feet, the finished depth or thickness and the R-value it gives, the vapour and air barrier work, the venting and baffles for an attic, any removal, how old insulation will be checked for vermiculite, clean-up, who asks the City about a permit, and start and finish dates. For spray foam, add open-cell or closed-cell and proof of the CAN/ULC-S705.2 standard.
Does an insulation price include taking the old insulation out?
Check the quote: published price pages list removal separately, at about $0.75 to $2 per square foot for clean insulation in 2025–2026 estimates, before any contamination or asbestos work. If the old material may be vermiculite, Health Canada says to have it tested before anyone disturbs it.
Have a different question?
Get answers about insulation costs, the Building Code, rebates, vermiculite and hiring in Ottawa from R-Value IQ.
Ready to Get Quotes?
Get matched with a local insulation contractor in Ottawa. Free, no obligation.