Batt Insulation in Open Walls
Fitting batts into open stud walls and ceilings during a renovation or addition, with the vapour and air barrier done before the board goes up.
No price with two independent published sources; compare written quotes for the same area and R-value.
Find an Insulation ContractorAbout Batt Insulation in Open Walls
Batts must fill the full width and length of the space between the framing and give a reasonably uniform insulating value over the whole face (O. Reg. 163/24, 9.25.2.3). Natural Resources Canada lists glass-fibre batts at about R-3.2 per inch.
The vapour barrier protects the warm side (9.25.4.3) and has a permeance no higher than 60 ng/(Pa·s·m²) (9.25.4.2). Where a sheet is the air barrier, its joints are sealed or lapped at least 100 mm and clamped (9.25.3.3).
When a renovation opens walls, the Code's renovation rule applies: the work cannot leave the house worse than before (11.3.1.1), and where the framing being altered matches the existing framing, lesser amounts of insulation and vapour barrier are acceptable (Table 11.5.1.1.-C, C207). New additions in Ottawa follow their own table: R-19 plus R-5 continuous in above-grade walls (SB-12, Table 3.1.1.11).
Hanging, taping and finishing the drywall over the insulation is drywall work, not this site's. Removing walls is on the City's permit list; ask the City before walls are opened. We found no batt price with two independent published sources.
What This Work Covers
- Batts fill the cavity full width and length
- Vapour barrier on the warm side, joints lapped or sealed
- Air barrier details at outlets and top plates
- R-value per cavity stated in the quote
- Ready for the drywall crew
Popular For
Common questions about batt insulation in open walls
- What R-value goes in walls opened to the studs in Ottawa?
- Glass fibre batts in Ottawa walls: how much R-value per inch?
- Insulating a room over the garage in Kanata: any published price?
- Exposed floors in new Ottawa houses: which R-value applies?
- How do I read the R-value on an Ottawa insulation quote?
- Does insulating a basement as part of finishing it need an Ottawa permit?
- Where does the air barrier go in an Ottawa basement?
- When can my family go back in after spray foam in Orleans?
Other Insulation Services
Attic Insulation
Blowing loose-fill insulation over the attic floor, or topping up what is already there, with the eave vents and baffles kept clear.
Spray Foam Insulation
Open-cell or closed-cell foam sprayed into walls, rim joists, basements or roofs, applied to the standard the Building Code names.
Basement Wall Insulation
Insulating concrete foundation walls and rim joists from the inside, with the air and vapour barrier details the Code asks for.
Insulating Existing Walls
Blowing or dense-packing insulation into closed wood-frame walls, or adding insulation on the outside when the cladding comes off.
Crawl Space & Exposed Floor Insulation
Insulating crawl space walls and floors that sit over cold space, such as a room over an unheated garage or an overhang.
Air Sealing
Sealing the gaps where heated air leaks into the attic, walls and rim joists, done with the house's ventilation in mind.
Old Insulation Removal
Taking out old, wet or damaged attic insulation before new insulation goes in, quoted separately and checked for vermiculite first.
Ready to Get Started?
Tell us about your batt insulation in open walls job and we'll send it to local insulation contractors in Ottawa. They reply by email.