Insulating Existing Walls
Blowing or dense-packing insulation into closed wood-frame walls, or adding insulation on the outside when the cladding comes off.
No price with two independent published sources; compare written quotes for the same wall area, method and R-value.
Find an Insulation ContractorAbout Insulating Existing Walls
Ontario's Building Code allows loose-fill insulation in the wood-frame walls of existing buildings (O. Reg. 163/24, 9.25.2.4.(3)). Its explanatory note warns that adding insulation to existing wood-frame walls increases the likelihood of moisture damage to framing and cladding, and suggests sealing openings, coating the inside with a low-permeability paint, and checking the siding, flashing and caulking before the retrofit.
New houses and additions in Ottawa get R-22 in above-grade walls, or R-19 plus R-5 continuous, under the Code's energy standard (SB-12 Zone 1). For an existing house being reframed to match its existing framing, the Code accepts lesser amounts of insulation and vapour barrier (Table 11.5.1.1.-C, C207).
Adding or removing walls and enlarging a window are on the City's permit list. Adding insulation on its own is not named on the City's permit lists, so ask the City before walls or the roof are opened.
Older walls can hold surprises. Health Canada says to assume vermiculite produced before 1990 may contain some asbestos and not to disturb it, and urea formaldehyde foam insulation (UFFI) has been prohibited in Canada since December 1980. Testing and removal are abatement work (ottawaabatement.com).
We found no wall-insulation price with two independent published sources, so none is shown. Compare written quotes for the same wall area, method and R-value.
What This Work Covers
- Method named: blown, dense-packed or exterior insulation
- Openings sealed and the outside checked before filling
- Wall area and target R-value stated
- Permit question asked before walls are opened
- Old wall insulation identified first
Popular For
What this work costs
Common questions about insulating existing walls
- Is there a published price for insulating existing walls in Ottawa?
- Should the siding be checked before blowing insulation into Ottawa walls?
- Can insulation be blown into closed walls of an older Ottawa house?
- What does Ontario's Code warn about insulating existing wood-frame walls?
- Glass fibre batts in Ottawa walls: how much R-value per inch?
- Opening walls to insulate in Westboro: does that trigger a permit?
- What should I check for in old walls before insulating in Alta Vista?
- Is there a rebate for insulating exterior walls in an Ottawa home?
Other Insulation Services
Attic Insulation
Blowing loose-fill insulation over the attic floor, or topping up what is already there, with the eave vents and baffles kept clear.
Spray Foam Insulation
Open-cell or closed-cell foam sprayed into walls, rim joists, basements or roofs, applied to the standard the Building Code names.
Basement Wall Insulation
Insulating concrete foundation walls and rim joists from the inside, with the air and vapour barrier details the Code asks for.
Crawl Space & Exposed Floor Insulation
Insulating crawl space walls and floors that sit over cold space, such as a room over an unheated garage or an overhang.
Air Sealing
Sealing the gaps where heated air leaks into the attic, walls and rim joists, done with the house's ventilation in mind.
Old Insulation Removal
Taking out old, wet or damaged attic insulation before new insulation goes in, quoted separately and checked for vermiculite first.
Batt Insulation in Open Walls
Fitting batts into open stud walls and ceilings during a renovation or addition, with the vapour and air barrier done before the board goes up.
Ready to Get Started?
Tell us about your insulating existing walls job and we'll send it to local insulation contractors in Ottawa. They reply by email.