Insulating Existing Walls in Ottawa: What to Compare
No published range on this page
The figures we found for blowing insulation into closed walls do not meet our two-independent-sources rule, so we show what to compare instead of a number.
Blowing or dense-packing insulation into the closed walls of an older house is priced job by job. Use the left column to compare two quotes on the same terms. The right column lists the program's exterior wall lines, which pay by the level added and are pro-rated by the share of wall insulated.
Checked October 2026. Published figures, not quotes: yours will differ.
Shown side by side, never subtracted: the rebate is paid later, if you qualify, and only while program funding lasts.
What you pay the contractor
No published range: compare two written quotes on these points.
- The wall area in square feet, and which walls (by side of the house).
- The material and the R-value added, which is also what the rebate table is keyed on.
- Where the holes are drilled (inside or outside) and who patches and finishes them.
- The pre-check the Code's note describes: sealing openings, and checking or repairing siding, flashing and caulking.
- Whether any wall is opened or removed (that can need a permit).
What the program may pay back, separately
The program's tables go by the level found at the contractor's in-home visit (attic stream) or at the first energy assessment (assessment path), so that visit sets the row, not this page.
The rules that touch this job
- Loose-fill insulation is permitted in wood-frame walls of existing buildings (Building Code 9.25.2.4.(3)).
- The Code's note to that clause warns that insulating existing walls increases the likelihood of moisture damage to framing and cladding, and lists steps first: seal openings, coat the inside with a low-permeability paint, and check and repair exterior siding, flashing and caulking (A-9.25.2.4.(3)).
- When walls are opened to the studs, Part 11 applies; where framing is matched to the existing, lesser amounts of insulation and vapour barrier are acceptable (compliance alternative C207(a)).
What the quote should list
- The wall area, the material and the R-value added.
- Drilling, patching and finishing, as named lines.
- The siding, flashing and caulking check, before work starts.
- If you sign at home, the contract must be in writing (Consumer Protection Act, any amount over $50) and you can cancel within 10 days of receiving your copy.
- A 10% holdback: Ontario's Construction Act says the payer shall retain 10% of the price until the lien period has passed.
- A WSIB clearance certificate, which you can ask any contractor for.
Permits
Adding insulation on its own is not named on either of the City of Ottawa's lists (projects that need a building permit and projects that do not). Ask the City before you start, and always before opening walls or changing the roof assembly. Adding or removing walls is on the City's permit list. Where a permit does apply, the City's 2026 fee for alterations is $12.75 per $1,000 of construction value, with a minimum fee of $117.00.
R-Value IQ answers behind this page
- Is there a published price for insulating existing walls in Ottawa?
- Can insulation be blown into closed walls of an older Ottawa house?
- Should the siding be checked before blowing insulation into Ottawa walls?
- What does Ontario's Code warn about insulating existing wood-frame walls?
- Opening walls to insulate in Westboro: does that trigger a permit?
- What R-value goes in walls opened to the studs in Ottawa?
Quick answers
Why is there no price for existing walls?
The figures we found for this job do not meet our rule of two independent sources agreeing on the same measure. Two written quotes on the same terms will tell you more.
Is insulating closed walls on the City's permit lists?
It is not named on the City's lists. Ask the City first; opening, adding or removing walls is on the permit list.
Want this done at your place?
Tell us which part of the house you want insulated and we'll send it to local Ottawa insulation contractors, who reply by email. We send it out to local contractors for you. Free, no pressure.