How do I read the R-value on an Ottawa insulation quote?
How do I read the R-value on an Ottawa insulation quote?
When a contractor writes an R-value on a quote, it is the thermal resistance of the insulation material itself, measured in imperial units. A higher number means more resistance to heat flow. The number does not include the wall framing, the drywall, the sheathing or any air gap unless the quote says so explicitly.
What the number on the quote actually covers
The R-value a contractor quotes is the nominal value of the insulation product at the thickness being installed. Natural Resources Canada publishes design values per inch: blown cellulose (settled thickness) about R-3.6 per inch, glass fibre batt about R-3.2, mineral fibre batt about R-3.4, closed-cell spray foam about R-6, open-cell spray foam about R-3.6, extruded polystyrene board about R-5. Natural Resources Canada notes that products of the same class vary, and that a long-term value claimed above about R-6.5 per inch may not be substantiated. If a quote claims a higher per-inch figure than those, ask the contractor for the product's published data sheet.
The quote should also say where the insulation goes: the full attic floor, the basement wall from top to bottom, the rim joist, or the wall cavity. R-value without a location is incomplete, because the same number means different things depending on what assembly it is part of.
A few things to check on any quote:
- Is the R-value the finished, in-place value after installation, or the product's rated value per inch?
- Does the quote separate the insulation R-value from any continuous insulation layer? The Ontario Building Code's energy standard for housing, SB-12, treats continuous insulation (written "ci") as a distinct layer.
- If there is existing insulation, does the quoted R-value describe only the new material, or the combined total? Ask which one.
- For attic work, does the quote state the finished depth across the whole attic floor?
If the quote is for a new house or an addition, SB-12 sets minimum R-values by assembly: for example, R-60 in an attic with attic space, R-20 ci for a basement wall, under Package A1. Those are minimums for new construction and additions only, not targets for existing homes.
Before you sign, ask the contractor to write the finished R-value, the material and the thickness for each part of the house the quote covers.
Related service: Spray Foam Insulation What it costs: Spray foam
Want this done at your place?
Tell us which part of the house you want insulated and we'll send it to local Ottawa insulation contractors, who reply by email. We send it out to local contractors for you. Free, no pressure.
R-Value IQ -- Built from the Ontario Building Code, Ontario regulations and City of Ottawa sources and real construction experience. Answers are for informational purposes only and are not a professional assessment.
Ready to Get Quotes?
Find local insulation contractors in Ottawa. Free matching, no obligation.